![]() If you only plan to use your interface with a MIDI sequencer, the sequncer will handle all routings and no changes should be made to your interface's default routings. Check the web, Microcenter, eBay, Amazon, etc.īut to confirm what I reiterated previously, this is from the horses mouth (MOTU).Ĭlockworks is used for cable routing (like a MIDI patchbay), as well as other settings such as pedal settings, sync settings, etc. If I'm not mistaken you'll need a usb to DB25 cable. I think your unit has a legacy parallel port. Seems to me that there is something not right with the word clock setup. I have tried I'll check if I can modify the clock settings from the front panel. I'm running the MOTU in standalone mode as I don't have a mac and cannot figure out how to connect it to a PC. The mixer and ADAT are only connected via optical cables. Any ideas about how to fix this? Do i need some other Word Clock equipment. I also have the ADAT XT linked via optical cable to the Yamaha 03D mixer - I often get a YGDAI input SYNC Error with lots of popping from the mixer despite the mixer and ADAT both being set to 48Khz. MPC > MOTU Midi timepiece II (MIDI patchbay) > JL Cooper Data Master > ADAT XT I can kind of manage it the other way round where the ADAT is the slave and the MPC One is the master with the MPC One midi output port set to Sync, so I think the right connections with cables etc are in place.Īny ideas how I need to set the MPC One as a Slave to the ADAT XT Multitrack? I have the MPC One set to receive MTC and MMC but it doens't seem to receive any info and I can't see how to set it as a slave. I am struggling to set the MPC One as a slave so that it is locked to and triggered by the ADAT. I have an MPC One and I am trying to set it up with the ADAT XT multitrack via MIDI (MTC and MMC). I'm new to the MPC and the forum and wonder if you can help?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |